Clecoed the HS-905, HS-1004, and HS-905 ribs to the HS-1002 front spar and match drilled per the plans.  I did use the 90 degree drill attachment for the first time to match drill the inboard HS-905/HS-1004 holes into the HS-1002 front spar.

The HS is rather long.  Those are two “EAA” standard 5′ tables and a 4′ table made from the scrap of the plywood from the other two tables.  If I were building the tables again I would make them taller as the standard height is SHORT for my preference.  I would prefer not bending over as much to work at table height for drilling etc.  Also I would make the tops overhang and inch and a half all the way around for a clamping area.  The shelf is nice and does work well at elevating the stored stuff for easier access.

Carpet is set loose atop the tables.